Skip to content

How the leveling system works

A leveling system keeps tiles at the same height while the mortar sets. You place clips under the tile, tighten them with a wedge or cap, and knock them off afterwards.

Row of yellow wedges in clips along one long joint, low over a dark tile floor

What is lippage?

Lippage is a height difference between two tiles. Large formats are more prone to it, because they are often slightly bowed and the mortar can still settle under the tile. A leveling system pulls the edges into one plane.

In three steps

  1. Place the clips

    Set the clips in the mortar under the tile, 8 to 10 cm from the edge. Then lay the next tile.

  2. Tighten

    Slide in the wedge or fit the cap on the clip, and tighten until the tiles are level.

  3. Knock off and keep

    Once the mortar has set, knock the clip off with a rubber mallet. Keep the wedges or caps for the next job.

Wedge or spin?

Both systems do the same job. You choose by joint width, tile thickness and how you like to tighten.

Wedge system

Parts
Clip and wedge
Tightening
Slide the wedge in, by hand or with the pliers
Joint width
1 to 3 mm, outdoor 2 to 3 mm
Tile thickness
4 to 30 mm, outdoor 20 to 40 mm
Reusable
Wedges, 10 to 20 times

Spin system

Parts
Clip and cap
Tightening
Screw the cap onto the clip, by hand or with the wrench
Joint width
1 to 2 mm
Tile thickness
14 to 30 mm
Reusable
Caps, 10 to 20 times

Questions from tile installers

Which clip should I choose?

Choose the joint width first, because the thickness of the clip is the width of the joint. Then check that your tile thickness suits that clip. Example with a 10 mm tile: a 1.5 mm joint means ILM-CL-1.5 (tiles from 4 to 12 mm), a 2 mm joint means ILM-CL-2.0 (tiles from 9 to 20 mm). A 3 mm joint is not possible, because ILM-CL-3.0 is for tiles from 20 to 30 mm.

How many clips per m² for 60x60 tiles?

Allow 20 to 25 clips per m² with ILM-CL-1.0, ILM-CL-1.5 and ILM-SC-1.0. With ILM-CL-2.0, ILM-CL-3.0, ILM-SC-2.0 and the outdoor clips, allow 15 to 20.

Can I reuse the wedges?

Yes. You can use wedges and caps 10 to 20 times. The clips themselves are single use: you knock them off once the mortar has set.

Should I choose wedge or spin?

Below 14 mm, choose the wedge system, because spin clips start at 14 mm. From 14 to 30 mm, either works. It comes down to how you like to work: a wedge with pliers or a cap with a wrench.

Can I use it outdoors?

Yes. ILM-OCL-2.0 and ILM-OCL-3.0 are made for outdoor floors with tiles from 20 to 40 mm. According to the catalogue, spin clips also suit outdoor use, for tiles from 14 to 30 mm.

Calculate your usage

Enter the area and tile size, and read off the bags and boxes.

Go to the calculator